- Check for power to the actuator

Level of Difficulty - HIGH

Estimated Completion Time - 15 minutes

TASKI - SWINGO XP

Tools Required

Tool
Screwdriver-flat tip
Screwdriver-phillips
Volt meter (True RMS capable)

Parts Required

Step

Procedure & Parts & Tools

REMOVE THE 3 SCREWS HOLDING THE POWER BOARD.

Screwdriver-phillips

PULL THE POWER BOARD DOWN AND REST IT ON THE STEPBOARD.

LOCATE THE RED AND BLACK WIRES LABELED DR (DRIVE MOTOR RIGHT) AND DL (DRIVE MOTOR LEFT). PULL THESE CONNECTORS TO TEMPORARILY DISABLE THE DRIVE MOTORS. YOU WILL NEED TO DISCONNECT THE DRIVE MOTORS SO THE MACHINE DOESN'T MOVE.

Screwdriver-phillips

TO ACTIVATE THE MACHINE, TURN THE KEY ON. YOU WILL NEED TO BYPASS THE STEPBOARD SWITCH AS THE MACHINE WILL NOT ACTIVATE WITHOUT SOMEONE STANDING ON THE STEP BOARD. TO BYPASS THE STEP BOARD SWITCH, LOCATE THE STEP BOARD SWITCH UNDER STEP BOARD. INSERT SCREWDRIVER ABOVE SWITCH AND BELOW THE STEP BOARD.

Screwdriver-flat tip

LOCATE THE PLUG ON THE POWER BOARD LABELED "BRUSH LIFT". INSERT THE LEADS INTO PLUG AND ACTIVATE THE BRUSH LIFT. THE VOLT METER SHOULD READ 24 VOLTS. IF THE ACTUATOR IS OKAY, REVERSE STEPS 1 THRU 4 TO REASSEMBLE THE MACHINE.

Volt meter (True RMS capable)